PC Water Cooling

I’m showing below blocks that I recently made.

I tested the block GPU on 9500GT and 8800GTS. I know that many could be changed but I first milled the copper and I did not know if anything would come out of it. Top was made of polycarbonate, the block is 6mm thick, I milled to a depth of 3.5mm.

Temperatures at 8800GTS without OC decrased from over 80 oC to around 43oC in stress compared to AC and to 36 oC in idle.

 

Block CPU

Thickness 10mm, milling depth 7mm.

The milling time of the only pins is over 5 hours, there are about 180.

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *